* Permit and Planning fees can now be accepted via card transaction (processing fees apply) *
Responsibility for information: Although staff members will aid you with general questions about completing the forms, it is ultimately your responsibility to provide accurate information.
NO BUILDING PERMITS ARE REQUIRED FOR THE PROJECTS LISTED BELOW:
One-story detached accessory buildings used as tool or storage sheds, playhouses and similar uses, provided the projected floor area does not exceed:120 square feet Commercial or 200 square feet Residential.
Fences not over 6 feet high (six feet in the side or rear yard area, and to a height not to exceed four feet in the front yard area) Other restrictions apply to corner lots.
Movable cases, counters and partitions not over 5 feet 9 inches tall.
Retaining walls, which are not over 4 feet in height measured from the bottom of the footing to the top of the wall, unless supporting a surcharge or impounding class I, II or II-A liquids.
Painting, papering, tiling, carpeting, cabinets, countertops and similar finish work.
Window awnings in Group R-3 and U Occupancies, supported by an exterior wall that do not project more than 54 inches from the exterior wall and do not require additional support.
Prefabricated swimming pools that are less than 24 inches (610 mm) deep.
Water tanks supported directly upon grade if the capacity does not exceed 5,000 gallons and ration of height to diameter or width does not exceed 2 to 1.
Swings and other playground equipment accessory to detached one and two family dwellings.
Decks not exceeding 200 hundred square feet in area, that are not more than 30 inches above grade at any point, are not attached to a dwelling and do not serve the exit door required by Section R311.4.
NOTE: Unless otherwise exempt, separate plumbing, electrical and mechanical permits will be required for the above-exempt items. Exemption from the permit requirements of this code shall not be deemed to grant authorization for any work to be done in any manner in violation of the provisions of this code or any other laws or ordinances of this jurisdiction.
- Residential Building Permit – Use for New construction and/or Remodeling.
- Residential Plumbing Permit – Use this for bath/showers, sink, toilets, water heaters/softeners, water piping, dishwasher, lawn sprinkler, etc. – Plumbing permit fees are based on the number and type of fixtures installed, moved, or replaced.
- Residential Mechanical Permit – Use this for Furnace or Air Conditioning units, appliance vents, gas insert, gas piping, wall heater, stove hoods, vent vans, wood/pellet stove, etc.
- Commercial Building Permit – Use for New construction and/or Remodeling /Tenant Improvements- Permits will require review prior to permit issuance.
- Commercial Plumbing Permit – Commercial plumbing permits will require review prior to permit issuance.
- Commercial Mechanical Permit
- Fundraising Car Wash Permit
- Outside Utility Permit
- Sign Permit
- Nonconforming Use Permit
- Roofing Permit – Use for re-roofing, siding, and windows.
- Footing and Foundation Permit
BUILDING DEPARTMENT CONTACTS:
Building Official: Jeff Peters
Phone: 509-698-7365 or email email@example.com
Building Inspector: Roy Brons
Phone: 509-698-7365 or e-mail firstname.lastname@example.org
Planning & Building Assistant: Brandy Atkins
Phone: 509-698-7365 or email email@example.com
Stormwater Compliance Officer: Erin Barnett
Phone: 509-698-7331 or email firstname.lastname@example.org
General: Typical Foundation/Roof Load Requirements:
- Minimum Frost Depth – 24 inches
- Earthquake Zone- 2
- Seismic Area – C
- Wind 110 mph, Exposure 2
- Snow load 30 pounds per square foot
Building drawings: These drawings are needed to indicate how the structure will be built. A floor plan showing, location of plumbing fixtures, ventilation fans, size and type of heating and cooling equipment, etc. No deferred submittals will be accepted. A completed 2015 Prescriptive Energy Code packet must also be included in each building permit application. Click here to visit the WSU Energy Program website for information and forms to complete the packet.
Site Plan: Show the configuration and size of the lot that the building will be placed on and set back distance from the structure(s) to the property lines so staff can check for encroachments on public utility easements, right-of-way and compliance of the required set backs. For accurate setback measurement you will need to locate and measure from your property pins. Do not use fences and other such structures as those might give you an inaccurate measurement. Contact the Planning Department for complete set back requirements for property zones. Site plans must be drawn to acceptable scale.
Managing Stormwater in Selah: On February 16, 2007, the Eastern Washington Phase II Municipal Stormwater Permit came into effect. Selah falls under the ruling of this Phase II NPDES Permit and was required to create specific ordinances pertaining to Stormwater. Ordinance #1799 pertains to the design requirements for new development and for redevelopment, Selah Municipal Code (SMC) 9.23. The other Ordinance #1800, pertains to the control of sediment and erosion during construction (SMC) 9.24: https://www.municode.com/library/wa/selah/codes/code_of_ordinances
Residential project site plans must include a Stormwater Sediment and Control Plan and show Best Management Practices (BMP’s) that will be used on your construction site for sediment and erosion control. This site plan must be submitted at the time of application with the other building documents. The plan will be reviewed, approved and inspected by the Stormwater Compliance/Code Officer before construction can begin. During the construction phase of your project, regular construction site inspections will be made to ensure the plan is being followed and no sediment/water is being released off site.
NOTE: Any development that is (1) acre or larger will require a General Stormwater Permit through the Department of Ecology and a copy will need to be provided to the City prior to grading or movement of dirt. Visit the Washington State Department of Ecology (DOE) website for requirements and instructions on how to obtain the Construction Stormwater General Permit.
Review and Approval of Drawings: All building drawings/plans submitted for permitting purposes are reviewed through an outside consultant. Please see the coversheet on the building application packets for review and approval time of the drawings. If corrections are requested (2) sets of corrected plans will be required to be re-submitted for review and compliance with code and additional review time will be needed. The Consultant Review fees will be included in the permit fees and will be due when permits are picked up.
Revisions: Any deviations from the approved plans, must have prior approval from the Building Department. All changes must be documented for the record.
Permits and Inspections: No building or structure regulated by this code shall be erected, constructed, enlarged, altered, repaired, moved, improved, removed, converted or demolished unless a separate permit for each building or structure has first been obtained from the building official. All construction or work for which a permit is required shall be subject to inspection by the building official and all such construction or work shall remain accessible and exposed for inspection purposes until approved by the building official. FOR YOUR PROTECTION inspections must be conducted throughout the building, plumbing, and mechanical construction process. (Lines must be placed at property pins at time of setback and footing inspections). After each inspection, the inspector will sign off each appropriate box on the back of the permit, which must be posted at the job site. Call (509) 698-7365/66 for an inspection appointment request. Please review the City of Selah Building Guide for building permit application submittal/inspection requirements and other helpful information to guide you through the building application process.
Contractor Information: Washington State Law, RCW 18.27.110 requires that a contractor license number be on all building permits or work which is to be done by any contractor and that the contractor license number shall be verified. The contractor license number must be on the permit before it can be issued. All contractors working in the City of Selah must be registered to work in the City of Selah prior to issuance of a permit: https://selahwa.gov/business/
Call before you dig: Washington State Law required that before commencing any excavation of 12 inches or more, the excavator shall provide notice of the scheduled commencement of excavation to all owners of underground facilities through a one-number locator service. Failure to do so and which results in damaged utility can be costly to the excavator. Therefore, the one-call number for the Upper Yakima Valley Utilities Locate Center is 1-800-553-4344 or 811. This is a free call and no cost is required for the locate, and a 48 hour notice is required.
You can avoid unnecessary permit delays by carefully providing all required information. You may disregard items that do not address your particular building.